Dynavap The "M" Essentials Kit

The “M” Essentials Kit

The “M” Essentials Kit 2021 is the basic setup you need to get started vaping with DynaVap. This kit includes The “M” 2021 Dry Herb Vaporizer, a wooden vaporizer storage container called a SlimStash- Padauk and a Cyclone Triple Torch. The storage container is made from a type of wood called Padauk and is the perfect little travel container for your The “M” 2021 Dry Herb Vaporizer. DynaVap also offer the sleek SlimStash container in a number of different wood grains, including Zebrawood and African Mahogany. The Cyclone Triple Torch is a powerful little jet lighter and is wind resistant with triple flames. The translucent fuel tank means you can keep an eye on the butane level.

Currently only available in Padauk wood.

To learn more about how the DynaVap Vaporizer works, see the article: HOW TO USE YOUR DYNAVAP VAPORIZER.

How To Use: Dynavap The “M” Essentials Kit

Please read the instructions provided in the box before using the DynaVap The “M” Dry Herb Vaporizer.

Step 1: Fill the chamber

Open the vaporizer and load your finely ground herb material into the chamber. Make sure not to overpack it as you want the material to have some room to expand.

Step 2: Assemble and heat

Assemble the vaporizer and hold the vaporizer with one hand and use butane lighter or an induction heater to heat the cap of the vaporizer. Heat the cap until you hear a click.

Step 3: Inhale

Once you hear the click, start taking slow and steady draws from the mouthpiece. After a couple of draws, the cap will click again when it cools down. You can then either reheat the cap and continue your session or wait for the vaporizer to cool down further before emptying the chamber and reloading.

How To Clean: Dynavap The “M” Essentials Kit

Step 1: Disassembly the device

Carefully disassemble your DynaVap vaporizer into individual components.

Step 2: Soak the parts

Fill a small container with isopropyl alcohol and place disassembled parts into the alcohol and let them soak for a about 15 – 30 minutes. This will help break down and loosen any built-up residual.

Step 3: Scrubbing

After soaking, use cotton swabs to gently scrub away any remaining residue from various parts. Be thorough but gentle to avoid damaging the components.

Step 4: Drying the components

Allow all the cleaned parts to dry completely before reassembling the vaporizer.